Case study · Fort Worth, TX · 2018

Spalled slab repair on a self-storage third floor

The new slab started spalling within the first week after the pour. We took it down past the bad surface, rebuilt a smooth floor, and came back to seal it.

40,000 SF

Third floor

2018

Completed

4 steps

Bush hammer, grout, grind, seal

Close-up of the repaired slab after grinding

The problem

A new slab failing in its first week

Within a week of placement, the third-floor slab of a self-storage facility in Fort Worth began spalling across the surface. The weak top layer had to come off before any finish could go down.

What we did

We bush hammered the entire 40,000 square foot floor down past the bad surface, epoxy grouted the whole floor to fill the open, pitted concrete, then ground the grout back to a smooth, sound surface. Once the building was ready, we returned and sealed the floor.

Start to finish

How the floor came back

Bush hammering a spalled concrete slab on the third floor of a self-storage facility
1. Bush hammering
Bush hammered concrete surface with the spalled layer removed
2. Down past the bad surface
Epoxy grout spread across the entire third-floor slab
3. Epoxy grout, entire floor
Grinding the epoxy grouted slab smooth on a self-storage third floor
4. Grinding the grout
Epoxy grout being ground off to expose the repaired slab
5. Grinding the grout
Repaired concrete slab ground to a smooth surface
6. Ground smooth
Finished, sealed concrete hallway between storage units on the third floor
7. Sealed and finished
Sealed concrete floor in a self-storage hallway after the slab repair
8. Ready for tenants

Have a slab that needs repair?

Send the plans, finish schedule, and spec sections. We review the scope, flag prep and joint work up front, and get you a complete number.